Tip: use quotes for an exact phrase, e.g. "teacher education"
Rectangular lateral notches are not common engineering components, thus little research attention has been directed towards the investigation of their stress field properties. Indeed, no in-depth investigations have been conducted to date…
While a long stable crack propagation phase was observed during experiments of complex welded components, very conservative assessments of the fatigue life were achieved in the past. The difference was explained by the stress gradient…
According to Gradient Mechanics (GM), stress fields have to be determined by directly incorporating into the stress analysis a length scale which that takes into account the material microstructural features. This peculiar modus operandi…
This paper describes a novel method to model the stress gradient effect in fretting-fatigue. The analysis of the mechanical fields in the proximity of the contact edges allows to extract nonlocal intensity factors that take into account…
Nowadays lifetime calculation in the high cycle fatigue region is commonly based on S/N curves which are modified by different influences to ensure accurate results. Especially the application of these models is important when small…
The initial crack path is analysed in a fretting fatigue test with cylindrical contact, where there is a stress gradient and a multiaxial and non-proportional stress state. For this, a cylindrical pad is pressed, with a constant normal…
This work presents a new state update algorithm for small-strain associative elastic-plastic constitutive models, treating in a unified manner a wide class of deviatoric yield functions with linear or nonlinear strain-hardening. The…
Under the typical partial slip conditions under which fretting fatigue takes place, the amount of superficial damage is small. Therefore, the substantial reduction in fatigue life caused by fretting, when compared to plain fatigue, may…
Welded ‘T-junctions’ are tested at different load ratio for constant and variable amplitude loading. Fatigue results are analyzed through the type of fatigue mechanisms depending on the loading type. A gradient approach (WSG: Welded Stress…
The behavior of short cracks that depart from elastoplastic notch tips is modeled to estimate the stresses required to initiate and to propagate cracks in notched structural components, and to evaluate the size of tolerable crack-like…
Gradient Elasticity (GE) allows the stress analysis to be performed by taking into account the size of the dominant source of microstructural heterogeneity via a suitable length scale parameter. This is done by simply assuming that the…
When the width of cracked nanocomponents made of brittle or quasi-brittle materials is less than approximately , the size of the - dominance zone becomes smaller than and comparable to the fracture process zone ( ). The fracture process…
Crack initiation and propagation have been investigated on the polymeric material ABS (Acrylonitrile Butadiene Styrene), under ultrasonic fatigue testing. Three controlled actions were implemented in order to carry out fatigue tests at…
The aim of this work is to investigate stress gradient effects on the fatigue life estimation of notched Al 7050-T7451 specimens under combined torsion and push-pull loading conditions. Initially, simple push-pull and torsion fatigue tests…
Various input variables, including corrosion time, fretting force, stress, lubrication, heat-treating, and nano-particles, were evaluated by modeling of stress-controlled fatigue lifetimes in AlSi12CuNiMg aluminum alloy of the engine…
This paper demonstrates the application of continuous wavelet transform technique for magnetic flux leakage signal generated during a uniaxial fatigue test. This is a consideration as the magnetic signal is weak and susceptible to being…
This study represents a methodology to assess the probability of failure based on three the driving force formulations defined by the corresponding brittle and ductile fracture criteria for compact and bending specimens made of 34XH3MA and…
This article defines the main actions planned in the procedure of non-destructive testing and analysis of defects in the BK1 industrial mill of the cement plant of the GICA group. One of the subjects attracting the attention of researchers…
In the last years, a large amount of fatigue test results from plain and bluntly notched specimens made of AISI 304L stainless steel were synthetized in a single scatter band by adopting the specific heat loss per cycle (Q) as a damage…
