Tip: use quotes for an exact phrase, e.g. "teacher education"
Abstract. In this article, the effect of nano-clay particles and heat-treating on thermo-mechanical fatigue (TMF) behaviors and failures of piston aluminum-silicon (AlSi) alloys was investigated. For this purpose, thermo-mechanical fatigue…
The objective of the present paper is to investigate the stress-controlled low-cycle fatigue behavior of piston aluminum-silicon (AlSi) alloy reinforced with nano-clay particles and T6 heat-treatment. The piston aluminum-silicon alloy…
The results of the investigation of both mechanical and acoustic emission (AE) behaviors of Mg4Li5Al alloy subjected to compression and tensile tests at room temperature are compared with the test results obtained using the same alloy and…
Titanium alloy (Ti-6Al-4V) having a bimodal “harmonic structure”, which consists of coarsegrained structure surrounded by a network structure of fine grains, was fabricated by mechanical milling (MM) and spark plasma sintering (SPS) to…
Bamboo and wood are the most widely applied and the oldest natural structural materials in the world. Currently, worldwide output of wooden material is 1 billion ton, almost the same as steel. Most of them are used as structure, such as…
The aim of this work was to evaluate the influence of temperature on the mechanical behavior of an amorphous polymer, namely acrylonitrile butadiene styrene (ABS), based on a series of uniaxial tensile tests on smooth specimens at…
This study investigates the free vibration behavior of 3D-printed PA6 layered plates by considering the effects of stacking sequence, infill ratio, and boundary conditions. Unlike previous works, this research provides a comprehensive…
Le béton à hautes performances (BHP) est un béton innovant largement utilisé dans la construction moderne. De nouvelles techniques de formulation et de conception du HPC ont permis d'obtenir des performances mécaniques et une durabilité…
The stepped isostress method (SSM) is an advanced technique which allows the prediction of the long-term behavior and enables the construction of creep master curves of materials with short-term experimental tests. However, the performance…
In this paper, the finite element (FE) method was used to investigate the axial compressive behaviors of circular and square concrete filled aluminum tubes (CFAT). Firstly, the simulational results were compared with the experimental…
Microstructural characteristics, monotonic and strain-controlled cyclic axial behaviors of AW2099-T83 Aluminum-Lithium alloy were investigated. Grain sizes and structures are not uniform in the different orientations studied. High strength…
